Neural proof regarding lexical parafoveal running

These findings show that the surface of Cu electrocatalysts is dynamic during the CO2RR, and emphasize the importance of in situ characterization to understand the surface structure and its role in electrocatalysis.Controlling vapor nucleation on micro-/nanostructured surfaces is critical to achieving exciting droplet dynamics and condensation enhancement. However, the underlying mechanism of nucleation phenomena remains unclear because of its nature of nanoscale and transience, especially for the complex-structured surfaces. Manipulating vapor nucleation via the rational surface design of micro-/nanostructures is extremely challenging. Here, we fabricate hierarchical surfaces comprising tapered nanowire bunches and crisscross microgrooves. Nanosteps are formed around the top of the nanowire bunches, where the nanowires all around agglomerate densely because of surface tension. The theoretical analysis and molecular dynamics simulation show that nanostep morphologies that are around the top of the nanowire bunches can enable a lower energy barrier and a higher nucleation capability than those of the sparsely packed nanowires at the center and bottom of the nanowire bunches. Vapor condensation experiments demonstrate that the nucleation preferentially occurs around the top of the nanowire bunches. The results provide guidelines to design micro-/nanostructures for promoting vapor nucleation and droplet removal in condensation.Iron (Fe) is a growth-limiting micronutrient for phytoplankton in major areas of oceans and deposited wind-blown desert dust is a primary Fe source to these regions. Simulated atmospheric processing of four mineral dust proxies and two natural dust samples followed by subsequent growth studies of the marine planktic diatom Cyclotella meneghiniana in artificial sea-water (ASW) demonstrated higher growth response to ilmenite (FeTiO3) and hematite (α-Fe2O3) mixed with TiO2 than hematite alone. The processed dust treatment enhanced diatom growth owing to dissolved Fe (DFe) content. The fresh dust-treated cultures demonstrated growth enhancements without adding such dissolved Fe. These significant growth enhancements and dissolved Fe measurements indicated that diatoms acquire Fe from solid particles. When diatoms were physically separated from mineral dust particles, the growth responses become smaller. The post-mineralogy analysis of mineral dust proxies added to ASW showed a diatom-induced increased formation of goethite, where the amount of goethite formed correlated with observed enhanced growth. The current work suggests that ocean primary productivity may not only depend on dissolved Fe but also on suspended solid Fe particles and their mineralogy. Further, the diatom C. meneghiniana benefits more from mineral dust particles in direct contact with cells than from physically impeded particles, suggesting the possibility for alternate Fe-acquisition mechanism/s.Articular cartilage is a water-lubricated naturally occurring biological interface imparting unique mechanical and ultralow frictional properties in bone joints. Although the material of cartilage, synovial fluid composition, and their lubricating modes and properties have been extensively investigated at various scales experimentally, there is still a lack of understanding of load bearing, adhesion, and friction mechanisms of the cartilage-cartilage interface from an atomistic perspective under heavy loads. In this study, the effect of loading on adhesion and frictional behavior in articular cartilage is investigated with a proposed atomistic model for top layer cartilage-cartilage contact in unhydrated conditions using molecular dynamics (MD) simulations. Pull-off tests reveal that cohesive interactions occur at the interface due to formation of heavily interpenetrated atomistic sites leading to stretching and localized pulling of fragments during sliding. Sliding tests show that friction is load- and direction-dependent with the coefficient of friction (COF) obtained in the range of 0.20-0.75 at the interface for sliding in parallel and perpendicular directions to the collagen axis. These values are in good agreement with earlier nanoscale experimental results reported for the top layer cartilage-cartilage interface. The COF reduces with an increase in load and tends to be higher for the parallel sliding case than for the perpendicular case owing to the presence of the constant number of H-bonds. Overall, this work contributes toward understanding sliding in unhydrated biointerfaces, which is the precursor of wear, and provides insights into implant research.The spatial distribution of MOF functionalization reveals that postsynthetic modification (PSM)-derived microstructures can range from uniform to core-shell, affected by reagent reactivity and solvent choice. A suite of isocyanate reagents with varying reactivity were employed to study the effect of kinetics and experimental conditions on microstructure during PSM. Etrumadenant antagonist Exploiting the difference in reactivity between chloroacetyl isocyanate and 4-bromophenyl isocyanate, a one-pot PSM reaction produces a dual-functionalized core-shell structure. Furthermore, a triple-functionalized Matryoshka structure is formed in a two-step PSM procedure using trifluoroacetyl isocyanate followed by a self-sorting reaction with chloroacetyl isocyanate and 4-bromophenyl isocyanate, demonstrating that a better understanding of the dynamics of PSM can support the design of MOFs with increasingly sophisticated architectures.Manipulating the connectivity of external electrodes to central rings of carbon-based molecules in single molecule junctions is an effective route to tune their thermoelectrical properties. Here we investigate the connectivity dependence of the thermoelectric properties of a series of thiophene-diketopyrrolopyrrole (DPP) derivative molecules using density functional theory and tight-binding modeling, combined with quantum transport theory. We find a significant dependence of electrical conductance on the connectivity of the two thiophene rings attached to the DPP core. Interestingly, for connectivities corresponding to constructive quantum interference (CQI), different isomers obtained by rotating the thiophene rings possess the same electrical conductance while those corresponding to destructive quantum interference (DQI) show huge conductance variations upon ring rotation. Furthermore, we find that DQI connectivity leads to enhanced Seebeck coefficients, which can reach 500-700 μV/K. After including the contribution to the thermal conductance from phonons, the full figure of merit (ZT) for the CQI molecules could reach 1.